Drawings, projects, and notes

Colors :  Blue - Date and weeks work
             Red - drawings and projects
             Green - quizzes and test

Week of November 11 th

Week of November 4 th
Three dimensional drawings from sheets- Teacher will select and assign to student.  Students will complete 4 of the 12 drawings. 
Discussion on the purpose of Tolerances and Machine instructions - Ream, Drill, Broach, Cut, etc on drawings and part construction.


Week of October 25 th
Work on drawings from last week and prepare for quiz
Quiz on solid construction - extrusion and cutting 2 class periods
Drawings from sheet - students will complete three chosen by teacher.


Week of October 18 th
Discussion on view selection - which plane to start your drawing in, select the surface that show the most distinct details about the object.
Notes: Feature fillet command, Radius and Diameter(d, DIA, Drill, Ream...), review of solid commands and aspects of extrusions. 
  Drawings: Page 136-7 Fig 5-92
                                 Fig 5-93
                                 Fig 5-97
                                 Fig 5-99


Week of October 11 th
Notes: Three dimensional drawings
              Features - Extrude Boss/Base
                             Sketch Mode
                             Extrude
                             Building Block Method
                             Identification of view and plane
Drawings: Page 136 Fig 5-86
                              Fig 5-90
            Extra Credit Fig 5-98
Notes: Three Dimensional Drawings
               Features - Extrude cut
                              Sketch Mode
                              Cut
                             Clay Method - cut and remove
Drawings: Page 136 Fig 5-87
                              Fig 5-84
                              Fig 5- 85

Week of October 4 th
Quiz - Drawing that will layout of  horizontal, vertical, angled,
              and tangent lines, and  circle, and arcs.

Finish Drawings - Page 90 fig 3-94 cover plate, fig 3-95 housing
                 - Page 91 fig 3-101 adjustable sector,
                                fig 3-102 adjusting ring

Week of September 27 nd
Circles, Arcs, and Tangent lines
   Notes: created by class on wikispaces.com
             - Trim
             - sketch entities
             - sketch tools
             * Each student will create a section and this will be graded

   Drawings - Page 90 fig 3-94 cover plate, fig 3-95 housing
                 - Page 91 fig 3-101 adjustable sector,
                                fig 3-102 adjusting ring
  
Week of September 20 th
Angled Lines and layout
   Drawings - page 88 fig 3-81 Grill Plate
                - page 88 fig 3-82 Measurement

   Notes: Circles - radius vs  diameter, Layout of, command
   Drawings - page 89 fig 3-84 Cushioning Base

   Notes: Sketch relationships, tangent lines, circles and arcs,
                and layout
     Continue work on Cushioning Base

Week of September13 th
Horizontal and vertical lines
   Notes: line command and offset command
   Drawing - page 85 fig 3-65 Stencil
 
   Notes: Layout, Angled lines and Polar coordinates
   Drawing - page 87 figure 3-75 Shearing Blank

Week of September 6 rd
Introduction and class expectations
    Handout: class discription and expectations
    Notes: XYZ axis, XY, YZ, and XZ planes and their relationships

Solid Works introduction
   Began to use CADD software SolidWorks
       - log in process
       - Part, Assembly, and Drawing - identified
       - Sketch command and plane selection
       - Commands - line, offset, and trim
       - Reading drawings
   Drawing - Horizontal and Vertical lines
       page 86 fig 3-73 Inlay